Registered: Feb 2010
Location: Virginia
Posts: 288

Continuous red light. Happened while hunting. Will not cut off or on. No response when place on charge. Will updates or master reset help? Could be time to trade up...
Any help send it. Thx

Report this post to a moderator | IP: Logged

Registered: Jan 2016
Location: Central Pa
Posts: 1114

I'm no expert, just try to follow a logical trail on such things. First thing is disconnect the battery for a couple minutes and let everything reset. I doubt that will do it in this case, but worth a shot.

If that doesn't do it, next thing would be the On/Off switch you will see located on the board when you take it apart to disconnect the battery. . Make sure it's clicking and not stuck in between.

I doubt it will take any updates when it's not functioning properly, but I could be wrong.

Report this post to a moderator | IP: Logged

Registered: Feb 2014
Location: WV
Posts: 6

Plug the collar into charge. Press the power button 5 times. It should "chirp" after each press then after the final time it should tone 3 or 4 times. This should reset the collar without having to taking the collar apart to access the battery.

Report this post to a moderator | IP: Logged

Registered: Jan 2016
Location: Central Pa
Posts: 1114

quote:

---

Originally posted by Hutton Run
Plug the collar into charge. Press the power button 5 times. It should "chirp" after each press then after the final time it should tone 3 or 4 times. This should reset the collar without having to taking the collar apart to access the battery.

---

Report this post to a moderator | IP: Logged

Registered: Feb 2014
Location: WV
Posts: 6

No it does not work with the 30/40s. You will need to take them apart and unplug the battery. I have never tried a TT10/15 or T5 but would imagine it works the same with them as the 50s.

Report this post to a moderator | IP: Logged

Registered: Feb 2010
Location: Virginia
Posts: 288

tried a few things... no luck. just sent the collar back to garmin.

Report this post to a moderator | IP: Logged

Registered: Feb 2015
Location: California
Posts: 1150

Mine did that, I held the power button for 30 seconds and it shut off and was back to normal

Report this post to a moderator | IP: Logged

Registered: May 2008
Location: Gillett, Pa
Posts: 1876

collar needs a update can be done with 320 its been a couple of years since i done one add collar can you touch no enter a number 1thru 9 enter then update collar like i said its been a couple of years

Report this post to a moderator | IP: Logged

Registered: May 2016
Location: Palatka, FL
Posts: 5106

Duck is correct. Hold the off/on button down 30 seconds and it should clear up.

__________________
www.ConkeysOutdoors.com
"Boss Lights"

Report this post to a moderator | IP: Logged