Bruce m. Conkey
UKC Forum Member
Registered: May 2016
Location: Palatka, FL
Posts: 5106 |
Dan's Frogger Boots with Chaps
Dan's Frogger Boot with Dan's Chaps
Dan's Hunting Gear is excited to introduce their new Frogger Boot. Designed for the dedicated hunter who is looking for comfort and durability. Chemically resistant rubber for added protection and easy cleaning. Extra thick 2 mil. overlay, with additional rubber underlays in high puncture areas. The Gel-Comfort insole makes this boot remarkably comfortable. The Xtreme Traction tread is very aggressive in mud, rocks, and snow. This 16" boot is 100% waterproof. Steel shank in outsole. Comfort range -20 to 70 degrees F.
LOWER RUBBER SECTION SNAKE PROOF
5.6 lbs
Waterproof
Comfortable
Durable
Gel-comfort inside
Xtreme traction tread
Orange lining
Chap options: Dan's froglegs (chaps) are constructed using an outer layer of stout material that is lined with very water repellent nylon to help stop any moisture that gets through the outer layer, plus they easily turn briars. The nylon goes all the way down to the lower ankle of the boot, providing the boots and your legs with protection from sharp sticks and briars. They are carefully made, then sewn and sealed to the boot of your choice. Froglegs have adjustable straps that fasten to your belt with a 3/4" plastic buckle. Snaps are provided at the top of the chap and boot so they can be worn while folded down.
Heavyweight (Brush Buster) Chap: A tough, and long lasting chap made of 1000 denier Magnatuff fabric. Twice as thick as the lightweight chap and not as flexible. 100% waterproof
Five Star Chap: Dan's best selling chap is made of the same nylon fabric as Dan's Rugged Wear clothing and the former Wick Outdoor Works. Lightweight, flexible, and just as tough as the heavyweight chap. 100% waterproof
Snake Protector Chap: Heavyweight, three-ply chap that provides reliable protection from snakes. 100% waterproof
Chap Sizing- if you have any questions about sizing, please give us a call.
Thigh Measurement
Measure around the largest part of your leg (where the top of the chap will be). Take this measurement over the pants you normally wear hunting. Please do not add or subtract from the measurement you get. Do not pull the tape tight or leave it loose. We will add two inches to the measurement to allow for proper fit. Select your measurement from the drop down box below.
Inseam Measurement
Just supply the inseam of the pants you normally wear in the drop box below. We will subtract 3 inches from this measurement to ensure a proper length.
Visit the website:
http://www.conkeysoutdoors.com/cgi/...h-Dan%27s-Chaps
__________________
www.ConkeysOutdoors.com
"Boss Lights"
Last edited by Bruce m. Conkey on 06-05-2018 at 12:17 PM
Report this post to a moderator | IP: Logged
|