Lone Pine JB 
	UKC Forum Member 
	
	Registered: Sep 2004 
	Location: Brookville, PA 
	Posts: 2461  | 
	
	
	 
	 I have a Husky 357XP and a little Stihl 028.   
 
The Stihl is about a 1983 model and still runs like a champ.  It's my preferred saw. 
 
I wanted something a little bigger like a 360 stihl, but I went with the Husky.  BIG MISTAKE!!! 
 
The Husky is about 2004 model and is junk.  Hard to start, not enough power to run the chain through these hardwoods, and a gas hog.  It might be ok if you were only cutting pines... 
 
a buddy of mine just got a 310 this winter.  That thing will definately cut.  Nice saw, and cheap.  It's about $200 less than the Husky I got and it'll cut alot more. 
 
I've run some bigger saws when I was out West, 044 and 066. 
 
I definately think Stihl is the way to go. 
	
	__________________ 
"All that is necessary for the triumph of evil is that good men do nothing." (Edmund Burke) 
 
Lone Pine North 
	Last edited by Lone Pine JB on 04-26-2006 at 01:40 PM 
	Report this post to a moderator | IP: Logged 
	 |