Registered: Sep 2003
Location: logan, west virginia
Posts: 48

have a coon buster light. has a 5 position switch on high it burns fine all the time. the others it will burn for a few seconds then it's like it kicks off you can turn it back to high than back down and the same thing over again. changed switches and it's the same thing. don't know if the bulb could cause this or what?

Report this post to a moderator | IP: Logged

Registered: Apr 2006
Location:
Posts: 6548

most of the lights i have used will only burn on the high side in 1- 2 postions.

Last edited by Lee Currens Jr. on 06-17-2009 at 04:04 AM

Report this post to a moderator | IP: Logged

Registered: Dec 2004
Location: maryland
Posts: 596

fusable link installed as protection for over amperage.
usually installed in the high side circutry/ usually will stay on in the high and high position or all low positions. if you are in the hi ghside and in any position other tha high it will cycle off.

__________________
http://www.SPLITOAKKENNELSUPPLY.com
410-808-2151
Toll Free: 1-888-820-0431

Jeff Wilson

Report this post to a moderator | IP: Logged

Registered: Sep 2003
Location: logan, west virginia
Posts: 48

k so how do i fix it?

Report this post to a moderator | IP: Logged

Registered: Apr 2006
Location: Stanardsville,VA
Posts: 233

Is your light shutting off with the bulb on the high side?If so that is normal.The high side will only work with the switch turned up to 5.

Report this post to a moderator | IP: Logged

Registered: Jan 2009
Location: Flora ,IL
Posts: 69

WOW !!!! You mean I threw 2 lights in the trash because they were working fine ???
I had a Compitition Light that did that , only worked when it was crannked up wide open , I thought it was jusk ,so I trashed it. It worked fine when it was on the first click on the high side ,but when I would turn it up past that ,it would go off .


WHOOPS !!!!

__________________
Home of PR' Biehls' Atomic Thunder
RIP - Tenacious Jet
Get Em' Treed


When The Tailgate Drops ... The Lyin Stops !!!!

Report this post to a moderator | IP: Logged

Registered: Jun 2003
Location: AUBURN, IN.
Posts: 1706

some lights have a peppy-c in the circuit --we the light pulls too many amps the peepy-c will open up and will close when it cools down --I hope this put some light on your problem

__________________
ALLNITER DOUG CHEEK

ALWAYS GO BY THE RULES AND NEVER A PROBLEM

Report this post to a moderator | IP: Logged