UKC Forums (http://forums.ukcdogs.com/index.php)
- UKC Coonhounds (http://forums.ukcdogs.com/forumdisplay.php?forumid=4)
-- Wooden Kennel Floors (http://forums.ukcdogs.com/showthread.php?threadid=161028)

Wooden Kennel Floors

What is the best way to secure your kennels to a deck floor? I have the welded wire kennels that have the bar at the bottom. I'm just stumped on how the best way would be to secure them down.

Or do you think that they even have to be bolted down....?

U bolt with flat bar should work good, but, i dont have wood floors, so i do not know.

__________________
Sam Fox

Fox Logging
1-765-238-1694
I hunt Walkers. and a English puppy

Will the bottom rail be up of the floor. Does the 2 upright ends post keep bottom rail up off the floor some. If the uprights on both ends of kennel sections holds bottom rail off the floor, then I would just cut some 1/2" thick rubber and frame the kennel upright in on 2 sides on each upright so it can't move around. Screw down with galvinized screws. Worked for me in my welping kennel.

__________________
Danny G

If your bottom rail isnt to far off the floor, you can get a 2 hole strap from a store that sells electric material. They will have exact size for the rail and all you need to do is anchor it with a wood screw. ronnie hill

__________________
Gr Nt Ch Gr Ch Uncle Buck( ALH )R.I.P.
Gr Ch Hill's Rock N Roll Apache
Gr Ch Skyline BoJo
Hill’s Rock N Roll Reacher ( ALH )

i have my board nailed down to the frame work....... then used 1 1/2" EMt Pipe straps tie anchor the kennel down...

__________________
Lyndon Crosby
Cross-B Cooonhounds

Walkers:
AKC CH UKC GRCH 'PR' Stackem Up High
* 2011 AKC South Carolina State Reserve Bench CHampion
*2012 Ukc Louisiana State Youth Bench Show Champion
*Qualified for Lee Crawford Invitational
*2012 AKC Va State Bench Show Champion
*Qualified for 2012 UKC WORLD SHOW

UKC GRCH'PR' Harts Mill Whiskey Rose

New Redbone:

CH 'PR' Harts Mill Flame-N-Flare

floor

i used a floor that is a little bigger than the kennel and then you can screw a 2x4 around the outside and that will hold it in place